Resiners Resin Bubble Remover

Hi, I'm Brittany with WTI and I am a Craftaholic. And that's why my mind was blown when I found out something as amazing as this product existed. It is a resin bubble remover by Resiners. I have recently started getting into making resin jewelry and the bubbles are a big issue. This is basically a little chamber that you can put the cup of resin that you've poured the two A and B and stirred it fully in which usually causes the bubbles. You place it in there, you close it, make sure you follow the instructions that they have in there because they are very specific. You put it down, make sure the little opening is fully closed. It has this silicone piece that you close it that makes sure none of the air comes out. You plug it in. Up top it has the instructions where it has on off. And you have the A on the A-mode and that basically will determine how long it's going to do it. And then you just push play and it's actually just fascinating just to sit there and watch it. What's nice is that if you see that all the bubbles are gone, you can pause it. You can stop it at any point or allow it to finish its cycle when it beeps. You then unplug the plug which basically now releases the pressure of it sucking all of the air out and you let it sit open for about 30 seconds and then you can open it up and get the cup of resin. It was so amazing to see the difference. Having that assurity that the majority if not all the bubbles have been sucked out is a such a great relief for when you're trying to create beautiful jewelry. But don't just take my opinion, check it out for yourself because that's just my point of view.